?

1.MongoDB的启动和停止

启动部分

:\mysoft\mongo\bin>mongod.exe --help

?

** NOTE: when using MongoDB 32 bit, you are limited to about 2 gigabytes of data

?

** see http://blog.mongodb.org/post/137788967/32-bit-limitations

** with --dur, the limit is lower

?

Allowed options:

?

General options:

-h [ --help ] show this usage information

--version show version information

-f [ --config ] arg configuration file specifying additional options

-v [ --verbose ] be more verbose (include multiple times for more

verbosity e.g. -vvvvv)

--quiet quieter output

--port arg specify port number

--bind_ip arg comma separated list of ip addresses to listen on - all

local ips by default

--maxConns arg max number of simultaneous connections

--logpath arg log file to send write to instead of stdout - has to be

a file, not directory

--logappend append to logpath instead of over-writing

--pidfilepath arg full path to pidfile (if not set, no pidfile is

created)

--keyFile arg private key for cluster authentication (only for

replica sets)

--auth run with security

--cpu periodically show cpu and iowait utilization

--dbpath arg directory for datafiles

--diaglog arg 0=off 1=W 2=R 3=both 7=W+some reads

--directoryperdb each database will be stored in a separate directory

--journal enable journaling

--journalOptions arg journal diagnostic options

--ipv6 enable IPv6 support (disabled by default)

--jsonp allow JSONP access via http (has security implications)

--noauth run without security

--nohttpinterface disable http interface

--noprealloc disable data file preallocation - will often hurt

performance

--noscripting disable scripting engine

--notablescan do not allow table scans

--nssize arg (=16) .ns file size (in MB) for new databases

--objcheck inspect client data for validity on receipt

--profile arg 0=off 1=slow, 2=all

--quota limits each database to a certain number of files (8

default)

--quotaFiles arg number of files allower per db, requires --quota

--rest turn on simple rest api

--repair run repair on all dbs

--repairpath arg root directory for repair files - defaults to dbpath

--slowms arg (=100) value of slow for profile and console log

--smallfiles use a smaller default file size

--syncdelay arg (=60) seconds between disk syncs (0=never, but not

recommended)

--sysinfo print some diagnostic system information

--upgrade upgrade db if needed

?

Windows Service Control Manager options:

--install install mongodb service

--remove remove mongodb service

--reinstall reinstall mongodb service (equivilant of mongod

--remove followed by mongod --install)

--serviceName arg windows service name

--serviceDisplayName arg windows service display name

--serviceDescription arg windows service description

--serviceUser arg user name service executes as

--service